cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
362
Views
0
Helpful
2
Replies

Cable for PA-MC-8TE1+= port adapter

limtohsoon
Level 1
Level 1

Hi Sir,

For PA-MC-8TE1+= port adapter, can anyone confirm the correct cable is CAB-E1-RJ45BNC= (description: E1 Cable RJ45 to dual BNC (unbalanced), Spare)?

Thank you.

B.Rgds,

Lim TS

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

If you are going to a 75 Ohm circuit using BNC, yes.

Hope this helps, please rate post if it does!

Danilo Dy
VIP Alumni
VIP Alumni

Hi,

The PA-MC-8TE1+ port adapter uses shielded twisted-pair cables with RJ-48C connectors to connect to a PBX or to the Public Switched Telephone Network (PSTN).

Refer to http://www.cisco.com/en/US/docs/interfaces_modules/port_adapters/install_upgrade/multichannel_serial/8-port_multichannel_t1.ei_8pri_install_config/2738ins.html#wp1031384

Regards,

Dandy

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: