ibm blade centre switches

Unanswered Question
Dec 17th, 2007

Hi all, when we install a switch on the ibm blade centre, how would you map say one of the blades to a partcular vlan on the switch ?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mmelbourne Mon, 12/17/2007 - 06:38

The Cisco IGESMs are like a C2950 on a blade, but with ports GigabitEthernet0/1 - 14 mapping onto the blade slots 1-14. If you have two switches, then each blade will (at least one) connection to each switch, so you can perform various failover/load-balancing functions depending on your architecture.

Please rate useful posts!


This Discussion