cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1275
Views
0
Helpful
3
Replies

5505-can't connect to ASDM in transparent mode

cgibbons
Level 1
Level 1

Hello, I'm setting up an ASA 5505 in transparent mode. I can ping the ASA device on the network but I cannot connect via ASDM software. When I revert back to routed mode, no problems using ASDM. I'm connecting via enet cable from laptop to Ethernet 0/1 interface on ASA 5505. I try the 'http ipaddress subnet' command and it won't take it even tho it's the same IP as the device. Do the 'switchport access' command to E 0/1 and doesn't stick. Here's my config if it helps. I really appreciate your help!

firewall transparent

hostname ciscoasa

domain-name xxxx.state.tx.us

enable password xxx

names

!

interface Vlan1

nameif inside

security-level 100

!

interface Vlan2

nameif outside

security-level 0

!

interface Ethernet0/0

switchport access vlan 2

!

interface Ethernet0/1

!

interface Ethernet0/2

!

!

interface Ethernet0/4

!

interface Ethernet0/5

!

interface Ethernet0/6

!

interface Ethernet0/7

!

passwd xxxxxxxx encrypted

boot system disk0:/asa803-k8.bin

ftp mode passive

dns server-group DefaultDNS

domain-name xxxx.state.tx.us

access-list OUTSIDE-IN extended permit ip any any

pager lines 24

mtu inside 1500

mtu outside 1500

ip address xxx.xx.xx.xxx 255.255.255.0

icmp unreachable rate-limit 1 burst-size 1

no asdm history enable

arp timeout 14400

timeout xlate 3:00:00

timeout sunrpc 0:10:00 h323 0:05:00 h225 1:00:00 mgcp 0:05:00 mgcp-pat 0:05:00

timeout sip 0:30:00 sip_media 0:02:00 sip-invite 0:03:00 sip-disconnect 0:02:00

timeout uauth 0:05:00 absolute

dynamic-access-policy-record DfltAccessPolicy

http server enable

no snmp-server location

no snmp-server contact

snmp-server enable traps snmp authentication linkup linkdown coldstart

no crypto isakmp nat-traversal

telnet timeout 5

ssh timeout 5

console timeout 0

threat-detection basic-threat

threat-detection statistics access-list

!

class-map inspection_default

match default-inspection-traffic

!

!

policy-map type inspect dns preset_dns_map

parameters

message-length maximum 512

policy-map global_policy

class inspection_default

inspect dns preset_dns_map

inspect ftp

inspect h323 h225

inspect h323 ras

inspect rsh

inspect rtsp

inspect esmtp

inspect sqlnet

inspect skinny

inspect sunrpc

inspect xdmcp

inspect sip

inspect netbios

inspect tftp

!

service-policy global_policy global

prompt hostname context

Cryptochecksum:xxx

: end

3 Replies 3

dexter.lagrand
Level 1
Level 1

I am having this problem as well. Is there a solution?

lm20ele
Level 1
Level 1

Have you tried already?

http xxx.xxx.x.x 255.255.255.255 outside

http://www.cisco.com/en/US/docs/security/asa/asa72/configuration/guide/mgaccess.html#wp1047288

husycisco
Level 7
Level 7

Hi

Try following

http ipaddress subnet inside

Regards

Review Cisco Networking products for a $25 gift card