12-17-2007 10:53 AM - edited 03-03-2019 07:57 PM
Hello.
I have a Cisco 837 and wondered if the DSL FW can be upgraded like the 877's can? Here's it's output.
Router#sh dsl int atm0
ATU-R (DS) ATU-C (US)
Modem Status: Showtime (DMTDSL_SHOWTIME)
DSL Mode: ITU G.992.1 (G.DMT)
ITU STD NUM: 0x01 0x01
Vendor ID: 'ALCB' 'GSPN'
Vendor Specific: 0x0000 0x0008
Vendor Country: 0x00 0xFF
Capacity Used: 96% 59%
Noise Margin: 4.0 dB 14.0 dB
Output Power: 19.0 dBm 3.5 dBm
Attenuation: 45.5 dB 31.5 dB
Defect Status: None None
Last Fail Code: None
Selftest Result: 0x00
Subfunction: 0x15
Interrupts: 646 (1 spurious)
Activations: 1
Init FW: embedded
Operartion FW: embedded
SW Version: 3.9.220
FW Version: 0x1A04
It disconnects a few times a day, if not I guess I will have to upgrade to an 877.
Thanks
Solved! Go to Solution.
12-17-2007 10:58 AM
Hi, according to:
http://cisco.com/en/US/products/hw/routers/ps221/prod_bulletin0900aecd801d5c4c.html
you are running latest FW and cannot be upgraded. Some tweaking can be tried with dsl command, but personally I'm always a bit way of that.
Hope this helps, please rate post if it does!
12-17-2007 10:58 AM
Hi, according to:
http://cisco.com/en/US/products/hw/routers/ps221/prod_bulletin0900aecd801d5c4c.html
you are running latest FW and cannot be upgraded. Some tweaking can be tried with dsl command, but personally I'm always a bit way of that.
Hope this helps, please rate post if it does!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: