Cisco 2821 gateway not register callmanager 5.0

Unanswered Question
Dec 18th, 2007

My cisco gateway 2821 is not registoring with callmanager 5.0

i have put following configuration in cisco 2821 gateway

dial-peer voice 21 voip

destination-pattern .....

voice-class codec 1

session target ipv4:X.X.X.X

voice class codec 1

codec preference 1 g729r8

codec preference 2 g729br8

codec preference 3 g711ulaw

voice service voip

h323

Get integrate with gatekeeper

interface Loopback0

ip address X.X.X.X 255.255.255.255

ip pim sparse-dense-mode

h323-gateway voip interface

h323-gateway voip id hswan ipaddr X.X.X.X 1718 priority 10

h323-gateway voip h323-id gw_1

h323-gateway voip tech-prefix 1#

h323-gateway voip bind srcaddr

X.X.X.X

and at callmanager end i have add cisco 2821 as H323 gateway,

But when i have check the status of VOIP gateway over CallManager, there Staus is not Unknown

If any one have any solution plz let me know

Arun Sharma

M--09988445070

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
allan.thomas Tue, 12/18/2007 - 03:16

For your information, H323 Gateways do not register with CCM as they do with MGCP.

You can obviously debug h323 h225 to verify whether you see messages from CallManager, however it would be easier to configure the H323 gateway name in CCM with the IP address with which you binding h323.

Although the gateway status is always shown as unknown, the IP address should be shown if you configure the endpoint as above, this indicate that both are communicating.

Regards

Allan.

Actions

This Discussion