IPM action configuration

Unanswered Question
Dec 18th, 2007

Hi all,

I have configured the IPM to test an IP address on port 8080 and to send a SNMP trap when a threshold is rised.

But i can't find where i should define the SNMP trap receiver in the application. Is it only the DFM that can receive the trap or can i define another SNMP trap collector ?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
MathieuJM_2 Tue, 12/18/2007 - 11:00

Thank you, so i will just configure the SNMP host in my source device to enable my event to send a trap.


This Discussion