PIX 7.2(2) Problem with Static NAT

Unanswered Question
Dec 20th, 2007

I have upgraded to 7.2(2) from 7.0(7) and I'm having the following problem.

I have two interfaces Outside 192.168.1.1/23 and Inside 172.16.1.10/24. I'm using the following static nat to hide addresses static (outside,inside) 172.16.20.0 192.168.1.0 netmask 255.255.255.0. When trafic for the network 172.16.20.0/24 arrives to the inside I receive a No route to host error.

The same configuration is working fine on PIX 7.0(7) and this problems I found it also in 7.2(3) 7.2(3)-12 8.0(2).

Does any one know what has changed in 7.2 or grater that makes this haven? any ideas to resolve this?

regards

Federico

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
husycisco Thu, 12/20/2007 - 14:35

Federico

Please post your config. And please define this traffic. From which IP in which interface does it come and what is the destination

Regards

federico.morales Fri, 12/21/2007 - 03:36

Thanks for your reply. I resolved the issue turning the static arround to: static (inside,outside) 192.168.1.0 172.16.20.0 netmask 255.255.255.0

I don not have a clear idea why this resolves the issue because this configuration was working till PIXOS 7.0(7)

The trafic is originated fron 172.16.10.10 (conected through a router 172.16.1.11 on the inside) with destination 172.16.20.80

If you can explain why this happens I would really appreciate it.

Regards,

Actions

This Discussion