2948 VLAN and port configuration

Unanswered Question
Dec 21st, 2007
User Badges:

I want to know what are the comands to setup a port on a old CATO's switch with the following information:

switchport access vlan XX

switchport mode access

no cdp enable

spanning-tree portfast

I can do that on a IOS, but I am strugling on the old system.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jon Marshall Fri, 12/21/2007 - 08:14
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN


switchport access vlan XX =

set vlan XX "port number"

switchport mode access =

no real equivalent really. All ports are access ports unless you set them up as trunks.

no cdp enable =

set cdp disable ( you can use this globally or on ports )

spanning-tree portfast =

set spantree portfast "port number"



diastiago Fri, 12/21/2007 - 08:36
User Badges:


Thanks for the quick reply. it works fine



This Discussion