12-22-2007 02:14 PM - edited 03-12-2019 05:54 PM
Could someone review my config? I need all traffic to flow accross the tunnel from one network to the next. I believe my access list and crypto map is right.
Solved! Go to Solution.
12-23-2007 07:37 AM
Crypto access list is fine but the access-list configured on the interface is also referencing the same access-list which is wrong.
Since you do not have the sysopt connection permit-IPSec command configured, you would be required to allow the IPsec traffic in your access-lists applied on the interface
Have a look at this link for a PIX-to-PIX IPSEC config example
http://www.cisco.com/warp/public/110/38.html
HTH
Narayan
12-23-2007 07:37 AM
Crypto access list is fine but the access-list configured on the interface is also referencing the same access-list which is wrong.
Since you do not have the sysopt connection permit-IPSec command configured, you would be required to allow the IPsec traffic in your access-lists applied on the interface
Have a look at this link for a PIX-to-PIX IPSEC config example
http://www.cisco.com/warp/public/110/38.html
HTH
Narayan
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: