Catalyst Express 500 not saving configuration from /exec mode

Unanswered Question
Dec 26th, 2007
User Badges:

I have some Express 500 switches that when I go into /exec mode and make a change to the port-security on one port and then the switch is powered off or loses power the change is gone. When I am done I do a copy run start and a wr mem. I looked to see if it is putting in the startup-config and it is in there. Any ideas of how can fix this? I have to make this change and I have had the same problem on a couple different ones.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion