12-27-2007 04:17 AM - edited 03-05-2019 08:10 PM
Guys,
Am I correct in saying the following for CatOS:
0x10F does the following
Switch to boot image from specified file. - If specified file is not there? does it just go into rommon mode?
Baud = 9600
Ignore config = disabled?
and
0x2102 does the following
uses the first file in flash? = what part of flash ?? If no file in flash? then use boot env?
Baud = 9600
Ignore config = disabled?
Could someone just clarify these points for me :
0x10f
If specified file is not there? does it just go into rommon mode?
0x2102
uses the first file in flash? = what part of flash ??
Many thx indeed, and Merry Christmas to all.
Ken
Solved! Go to Solution.
12-27-2007 07:57 AM
With CatOS, it's recommended that you enter a word option:rommon | bootflash | system
This URL is also useful on understating IOS values:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml
12-27-2007 07:19 AM
This URL should address your concern:
http://www.cisco.com/univercd/cc/td/doc/product/l3sw/8540/cnfg_gd/ccfg8540.htm
12-27-2007 07:36 AM
thx for that.
Just gonna sit down and work it out. its been such a long time :))))
Many thx
Ken
12-27-2007 07:38 AM
also, can I just confirm that CatOS is exactly the same as IOS for config-reg settings?
Thx
Ken
12-27-2007 07:57 AM
With CatOS, it's recommended that you enter a word option:rommon | bootflash | system
This URL is also useful on understating IOS values:
http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml
12-27-2007 08:00 AM
thx man. really good links :)
Thx for the help :)
Ken
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: