wlc anchor aaa override with 802.1x

Unanswered Question
Dec 27th, 2007

I have a 4402 WLC to act as an anchor controller in a DMZ enviroment.

My wireless clients associate with several WiSM's in the local network.

I would like to create a WLAN that uses 802.1x (WPA2) to authenticate the clients and then bind them to the anchor controller in the DMZ.

But I notice that the 802.1x part is being handled by the foreign controllers (WiSM's) and not by the anchor controller. So I cannot use the AAA override to assign different DMZ vlan's with my radius reply.

Is this correct ?


Gerard van Bon

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Scott Fella Thu, 12/27/2007 - 18:52

i don't think you can do that. you can put a client on a certain vlan, but since you are creating a mobility anchor to a 4402 in the DMZ, no way to push them to a WLC.

vanbon Sun, 12/30/2007 - 11:10


I now also think that it is not possible.


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode