wlc anchor aaa override with 802.1x

vanbon · ‎12-27-2007

I have a 4402 WLC to act as an anchor controller in a DMZ enviroment.

My wireless clients associate with several WiSM's in the local network.

I would like to create a WLAN that uses 802.1x (WPA2) to authenticate the clients and then bind them to the anchor controller in the DMZ.

But I notice that the 802.1x part is being handled by the foreign controllers (WiSM's) and not by the anchor controller. So I cannot use the AAA override to assign different DMZ vlan's with my radius reply.

Is this correct ?

Thanks,

Gerard van Bon

Scott Fella · ‎12-27-2007

i don't think you can do that. you can put a client on a certain vlan, but since you are creating a mobility anchor to a 4402 in the DMZ, no way to push them to a WLC.

-Scott
*** Please rate helpful posts ***

vanbon · ‎12-30-2007

Thanks,

I now also think that it is not possible.