7975 spare install

Unanswered Question
Dec 27th, 2007
User Badges:

I am replacing my 7941 with a 7975 spare. i am not getting any power on new 7975 and i am using the same port i use for the 7941. any suggestions

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Rob Huffman Thu, 12/27/2007 - 10:33
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi James,


You may be running into a PoE problem here, depending on what type of switch/switchport is being used. If you are using an older model that only supplies Cisco Pre-Standard PoE it won't fire up the 7975G :(


The 7941G can use either Cisco Pre-Standard PoE or the new standard IEEE 802.3af PoE.


Power Requirements:


The phone is interoperable with Cisco Pre-standard PoE and with IEEE 802.3af PoE (the phone is a Class 2 device); 48 VDC is required; it can be supplied locally at the desktop using an optional AC-to-DC power supply (part number CP-PWR-CUBE-3=).


From this good doc;


http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet0900aecd802ff012.html


The 7975G can only use IEEE 802.3af PoE


Power Requirements:


Supports IEEE 802.3af PoE (Class 3). 48VDC is required; it can be supplied locally at the desktop using an optional AC-to-DC power supply (part number CP-PWR-CUBE-3=) or power injector (CP-PWR-INJ=). Local power options require a corresponding AC country cord


http://www.cisco.com/en/US/products/hw/phones/ps379/products_data_sheet0900aecd8069bdb7.html


Hope this helps!

Rob

Cory Andrews Sat, 03/20/2010 - 14:43
User Badges:

Yes you'll need an IEEE 802.3af compliant PoE source to power your Cisco 7975G

Actions

This Discussion