I'm trying to configure a LAP1242 using the WLCM. Is there a basic setup guide available anywhere? I've done the searches and found lots of stuff, but none of it is "start from ground zero".
2811w/WLCM - 2960 - LAP1242
FA0/0.100 - wired clients 192.168.2.1/24
FA0/0.21 - LWAPPs 192.168.21.1/24
WL1/0 - WLC 192.168.20.1 /24
WL1/0.22 - Wireless Clients 192.168.22.1/24
WLC has IP of 20.1, management IP of 20.2, and AP Management IP of 20.3
Router has DHCP pool for 21 network with Option 43 value of 20.2 (the WLC)
So I reset the LWAPP to force the discovery, run a debug lwapp events enable on the controller, and see that it gets the discover and join and then I get a ton of Received LWAPP IMAGE_DATA_RES from AP , then it quits. The LWAPP *IS* getting an IP address from the DHCP pool, so I can ping it.. but no HTTP access. Where do I start (over)?
Thanks for any help!!!