×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ip address outside and ip address inside

Unanswered Question
Dec 27th, 2007
User Badges:

i am trying to setup a new pix firwall (525). i named the inside and the outside interfaces and set the security level on them , but when i try to assign an ip address for the inside and the outside the command fails, has anyone experienced this issue. any ideas, thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
johnd2310 Thu, 12/27/2007 - 12:58
User Badges:
  • Silver, 250 points or more

Hi,


we will need more info. What error do you get when you try to configure ip address?


regards

John

Aidswailem Thu, 12/27/2007 - 14:37
User Badges:

the error i get is :


pixname(config)# ip address outside A.B.C.C 255.255.255.0

^

ERROR: % Invalid input detected at '^' marker.

the same error for inside or outside.

Also when i try to type ip address ? there is no outside or inside option from the ? mark.

johnd2310 Fri, 12/28/2007 - 02:34
User Badges:
  • Silver, 250 points or more

hi,


what version of PIX os are you running? if you are running version 7.x or 8.x then you need to be in interface configuration i.e.

pixname(config-if)#


regards

John

Actions

This Discussion