12-27-2007 11:37 PM - edited 03-05-2019 08:11 PM
hi please help me, how can i configure VLAN to 3550 switch to connect 2960 switch?
im planning to use VTP? i have 3 switched connected tot he 3550 but i need only 1 VLAN for 2960 (with 10 users connected).
can you please tell how to do the configuration.
thanks.....
12-27-2007 11:54 PM
Do you mean to say that on one switch you do not need to have all the 3 vlans.
In that case you can allow only the particular vlan on the trunk connecting to 2960
on 3550
interface x/x --- connecting to 2960
switchport trunk encap dot1q
switchport mode trunk
switchport trunk allowed vlan
HTH
Narayan
01-01-2008 10:29 PM
hi royalblues,
do i need to use different subnet for my 2960 VLAn and use VTP for my 2 2950 and 1 2960 switch?
12-28-2007 12:44 AM
Hi Iceman ,
3550 :
Int vlan 10
ip address 10.10.10.x 255.255.255.0
no sh
int g0/30
switchport mode trunk
switchport trunk allowed vlan 10
2960 :
int vlan 10
ip address 10.10.10.254 255.255.255.0
no sh
int f0/48
switchport mode trunk
switchport trunk allowed vlan 10
ip-deafult gateway 10.10.10.1
In this case only vlan 10 is allowed between the switches.
Thanks,
satish
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide