12-27-2007 11:37 PM - edited 03-05-2019 08:11 PM
hi please help me, how can i configure VLAN to 3550 switch to connect 2960 switch?
im planning to use VTP? i have 3 switched connected tot he 3550 but i need only 1 VLAN for 2960 (with 10 users connected).
can you please tell how to do the configuration.
thanks.....
12-27-2007 11:54 PM
Do you mean to say that on one switch you do not need to have all the 3 vlans.
In that case you can allow only the particular vlan on the trunk connecting to 2960
on 3550
interface x/x --- connecting to 2960
switchport trunk encap dot1q
switchport mode trunk
switchport trunk allowed vlan
HTH
Narayan
01-01-2008 10:29 PM
hi royalblues,
do i need to use different subnet for my 2960 VLAn and use VTP for my 2 2950 and 1 2960 switch?
12-28-2007 12:44 AM
Hi Iceman ,
3550 :
Int vlan 10
ip address 10.10.10.x 255.255.255.0
no sh
int g0/30
switchport mode trunk
switchport trunk allowed vlan 10
2960 :
int vlan 10
ip address 10.10.10.254 255.255.255.0
no sh
int f0/48
switchport mode trunk
switchport trunk allowed vlan 10
ip-deafult gateway 10.10.10.1
In this case only vlan 10 is allowed between the switches.
Thanks,
satish
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: