Hi, I am just testing stuff on a cisco 837 DSL router and the Netflow tool. It seems Netflow has no idea regarding bandwidth utilisation on the dailer 1 and ethernet0 interface I'm monitoring. This is my output, can I tell Netflow my dialer 1(out) is 412kbp and the ethernet0 (in) is 4mb? I have I no chance :)
H0m3#sh dsl interface aTM 0
ATU-R (DS) ATU-C (US)
Modem Status: Showtime (DMTDSL_SHOWTIME)
DSL Mode: ITU G.992.1 (G.DMT)
ITU STD NUM: 0x01 0x01
Vendor ID: 'ALCB' 'GSPN'
Vendor Specific: 0x0000 0x0008
Vendor Country: 0x00 0xFF
Capacity Used: 97% 57%
Noise Margin: 7.0 dB 14.0 dB
Output Power: 19.0 dBm 3.0 dBm
Attenuation: 46.5 dB 31.5 dB
Defect Status: None None
Last Fail Code: None
Selftest Result: 0x00
Subfunction: 0x15
Interrupts: 659 (1 spurious)
Activations: 3
Init FW: embedded
Operartion FW: embedded
SW Version: 3.9.220
FW Version: 0x1A04
Interleave Fast Interleave Fast
Speed (kbps): 4224 0 416 0
Reed-Solomon EC: 11452 0 34 0
CRC Errors: 12 0 1 0
Header Errors: 11 0 0 0
Bit Errors: 0 0
BER Valid sec: 0 0
BER Invalid sec: 0 0
LOM Monitoring : Disabled