IAD2431 Load IOS

Unanswered Question
Dec 29th, 2007

I have an IAD2431 that the IOS has been deleted off of and I am trying to load via the Compact Flash but I keep getting errors and it will nto load. Any ideas on best way to load the IOS from ROMMON?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ccbootcamp Sat, 12/29/2007 - 10:20

What kind of errors are you getting from the CF? I suppose you could always do an XMODEM from ROMMON (assuming that's available on the IAD).

-brad

www.ccbootcamp.com

(please rate the post if this helps!)

Paolo Bevilacqua Sat, 12/29/2007 - 10:21

Type "tftpload" in rommon. It will tell you which parameters you have to set to load the image. To set a parameter, just type it followed by = and the value. Then connect the TFTP server to the lowest LAN and repeat the command, tftpload.

Hope this helps, please rate post if it does!

nshoe18 Sat, 12/29/2007 - 10:26

I am getting errors stating that the c2400-atafslib-m not found. I do not have an IP on the IAD so I do not think I can TFTP the IOS to it. I am trying to do it via XMODEM which of course is about a 4 1/2 hour process

Paolo Bevilacqua Sat, 12/29/2007 - 11:01

Exactly because of length via xmodem, TFTP is provided. The IP is given at the time you config as mentioned above.

Hope this helps, please rate post if it does!

Paolo Bevilacqua Sat, 12/29/2007 - 11:08

I don't seen rommon prompt or tftpdnld command in the file included. When turning on the router, send one or two breaks from the terminal program, and this will give you rommon.

Actions

This Discussion