12-30-2007 08:54 AM - edited 03-15-2019 07:59 AM
i have cisco call manager connected to the gateway 2851 that contains 28 fxo.
Some of ip phones must have inboud and outbound calls but via one direct line.
how can i configure it in the CCM and voice gateway ??
thanks at advance.
12-30-2007 08:59 AM
Do you use H.323 or MGCP to the GW ?
12-30-2007 09:06 AM
thanks for reply.
i use H323 protocol.
BR
12-30-2007 09:14 AM
For incoming, configure "connection plar XXX opx" where XXX is the extension where you want the call to be sent.
For outgoing, follow the configuration detailed at:
http://cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a00801bc341.shtml
Hope this helps, please rate post if it does!
12-30-2007 09:33 AM
thanks a lot for your help.
i will test it tomorrow and i will answer you
Thanks again.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide