reflector-port gig 0/15

Unanswered Question
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (2 ratings)
Loading.
jsivulka Fri, 01/04/2008 - 07:16
User Badges:
  • Bronze, 100 points or more

The reflector port is the mechanism that copies packets onto an RSPAN VLAN. The reflector port

forwards only the traffic from the RSPAN source session with which it is affiliated. Any device

connected to a port set as a reflector port loses connectivity until the RSPAN source session is

disabled.I am giving the correct formate but you have given invalid command

For example:

Switch 1- monitor session 1 source interface f0/6

monitor session 1 destination remote vlan 10 reflector-port

switch 2 - monitor session 1 source vlan 10

monitor session 1 destination interface f0/20 rx



ankbhasi Fri, 01/04/2008 - 08:44
User Badges:
  • Cisco Employee,

Hey Ali,


Yes it's been long we had conversation.Also I was not very active on forum in last few months. Was going busy with my work.


Howz is everything going in your network?


Regards,


Ankur

Actions

This Discussion