12-30-2007 09:49 AM - edited 03-05-2019 08:12 PM
Hi
SW1(config)#monitor session 1 destination remote vlan 500 reflector-port gi
SW1(config)#$sion 1 destination remote vlan 300 reflector-port gig0/15
monitor session 1 destination remote vlan 300 reflector-port gig0/15
^
% Invalid input detected at '^' marker.
Where can i put port-reflector?
10xs
01-04-2008 07:16 AM
The reflector port is the mechanism that copies packets onto an RSPAN VLAN. The reflector port
forwards only the traffic from the RSPAN source session with which it is affiliated. Any device
connected to a port set as a reflector port loses connectivity until the RSPAN source session is
disabled.I am giving the correct formate but you have given invalid command
For example:
Switch 1- monitor session 1 source interface f0/6
monitor session 1 destination remote vlan 10 reflector-port
switch 2 - monitor session 1 source vlan 10
monitor session 1 destination interface f0/20 rx
01-04-2008 08:25 AM
10xs
01-04-2008 08:34 AM
Hi Ali,
In addition to Joseph's post you can have a look at this link for some details on reflector port
Regards,
Ankur
01-04-2008 08:37 AM
Ankur my Freind howr you i miss you to much i sent you a hi with Amit
01-04-2008 08:44 AM
Hey Ali,
Yes it's been long we had conversation.Also I was not very active on forum in last few months. Was going busy with my work.
Howz is everything going in your network?
Regards,
Ankur
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: