cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
503
Views
10
Helpful
6
Replies

Ipv6 Again

alsayed
Level 1
Level 1

hello

Disabled Ipv6 on my 6509e720,but when i add any machine include Ipv6.the Brodcast come again..what can i do to stop that from the Core Switch.

10xs

6 Replies 6

royalblues
Level 10
Level 10

Ali,

IPv6 would be sending only multicast and no broadcasts. If any machine is configured for IPv6, they will send these multicast and the switch would mostly flood them.

Not sure if this will work but you can try denying the IPv6 packets on each port using an access-list

ipv6 access-list BLOCK deny ipv6 any any

interface x/y

ipv6 traffic-filter BLOCK in

HTH

Narayan

hello

can i appy these commands to interface Vlans

10xs

The reason to put the access-list on the port is to block the traffic entering the switch itself.

If it is applied on a interface vlan, the traffic would anyway be flooded on the vlan the incoming port was part of.

BTW, did you try this out in any one port?

Narayan

int gigabitEthernet 1/1

6509(config-if)#ipv6 traffic-filter blockin

^

% Invalid input detected at '^' marker.

look to this Output

sorry

6509(config-if)#ipv6 traffic-filter block in

any reply here

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: