Prefix list default sequence numbering

Answered Question

Hi All


Just wondering if it is possible to change the default behavior of prefix list sequence numbering so that instead of each line being sequenced 5 higher then the last I could change it to 10.


I understand that this can be achieved by entering a sequence number with each line I add, but I would like to know if the default can be changed on a global configuration level?


Best Regards & Best Wishes for 2008 and beyond,



Michael

Correct Answer by Edison Ortiz about 9 years 6 months ago

The default is 5 and as far I as I know, it can't be changed. However, you can disable the default with the no ip prefix-list sequence number command


http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte_bgh1.htm#wp1075211


Access List allows you to resequence afterwards ...


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Edison Ortiz Mon, 12/31/2007 - 11:52
User Badges:
  • Super Bronze, 10000 points or more
  • Hall of Fame,

    Founding Member

The default is 5 and as far I as I know, it can't be changed. However, you can disable the default with the no ip prefix-list sequence number command


http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hirp_r/rte_bgh1.htm#wp1075211


Access List allows you to resequence afterwards ...


Hi Edison


Cheers for the reply and the information. I guessed as much as I had googled and looked around the Cisco web site and found nothing.


I was aware that you could re-sequence and also that you can manually add the sequence numbers when building the prefix list. Just thought there might have been some obscure way to change the default value of 5.


Best Regards & Best Wishes for 2008 and beyond,



Michael

Actions

This Discussion