Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
298
Views
0
Helpful
1
Replies

1130AG with a 3524-PWR Switch

2044418Puts
Level 1
Level 1

‎01-01-2008 03:22 AM - edited ‎07-03-2021 03:09 PM

I'm trying to figure out if it is possible to feed this accesspoint with the Cisco Pre-standard Inline Power from a 3524-PWR switch.

When I turn on the Accesspoint it shows that there is not enough inline power available to turn the radio's on. According to the specifications it needs 12.95 Watt of power to do so. Can the 3524-PWR switch provide this amount of power? And can I just force the AP to assume there is a power injector installed without blowing up my switch?

Does Anyone have some specifications of the Cisco pre-standard inline power?

Labels:
0 Helpful
1 Reply 1

ankbhasi
Cisco Employee
Cisco Employee

‎01-01-2008 03:41 AM

Hi Friend,

See if this helps you

http://www.cisco.com/univercd/cc/td/doc/product/wireless/control/c44/ccfig42/c42lwap.htm#wp1111701

HTH

Ankur

*Pls rate all helpfull post

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card