How do you delete site-to-site vpn from asa 5510

Unanswered Question
Jan 1st, 2008

I have setup site-to-site vpn(s) on ASA5510. I used a wrong remote IP addy and tried to edit or delete it from the ASDM IPsec Rules and Tunnel policy to no success. I end up creating another site-to-site vpn with right remote IP addy. Is it a way to delete remote side host/network from asa5510 box? I tried edit, delete and nothing works. Please advice.

Thx,

Eric

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 3.8 (4 ratings)
Loading.
SteveDexter Tue, 01/01/2008 - 18:53

Connect to the ASA with telnet or ssh, do a show run and include the IP address of the remote host. And then do a no to the line.

srue Tue, 01/01/2008 - 19:14

clear configure crypto map 10

clear configure tunnel-group 10.1.1.1

*assumes '10' is the sequence number you want to get ride of, and that 10.1.1.1 is the wrong peer you have configured.

Eric Boadu Wed, 01/09/2008 - 11:51

Hello everyone,

Sorry for not responding. I was out for an emergency travel and just came back. Your config did the trick. I also removed them from the Global Objects on ASDM as well.

Thx,

Eric

ccbootcamp Tue, 01/01/2008 - 20:44

Can you post your config and the IP address you want to remove? I'll give the you exact commands to type.

-brad

www.ccbootcamp.com

(please rate the post if this helps!)

Actions

This Discussion