PIX failover problem

Unanswered Question
Jan 2nd, 2008
User Badges:

I have a pix 515 with stateful failover, we had a power outage and the primary will not re-assume primary status. If I turn both off and then turn on the primary we have no outside access. If I turn on the failover unit we get access back. when I do a show failover I see the following:

TCCPIX(config)# sh failover

Failover Off

Cable status: Normal

Failover unit Secondary

Failover LAN Interface: not Configured

Unit Poll frequency 15 seconds, holdtime 45 seconds

Interface Poll frequency 5 seconds, holdtime 25 seconds

Interface Policy 1

Monitored Interfaces 6 of 250 maximum


How do I get the Failover On?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
JORGE RODRIGUEZ Wed, 01/02/2008 - 13:26
User Badges:
  • Green, 3000 points or more

Hi, are your pixes failover connected by serial cable or lan base failover? either serial/lan base failover check failover physical connections, to enable failover bring-up the active and issue failover from enable mode to enable failover , do same for standby.




go over this link if running code 7.x

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml#acti



if runnign code 6.x

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a0080094ea7.shtml


Rgds

Jorge



Actions

This Discussion