cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
344
Views
10
Helpful
3
Replies

Couldn't get Route

alsayed
Level 1
Level 1

hello

i have a couple of question:

1)if you can ping the next hope but u didn't receive route from the next hop Although both are under Ospf 1.here what the problen is?

2)what is the purpose of:

R5(config-if)#ip ospf mtu-ignore

10xs

3 Replies 3

s.arunkumar
Level 3
Level 3

1.Check if the next hop router is ur ospf neighbor.(It can ping b'cas its directly connected)

If ospf there,then any filtering by distribution-list or filtering out lsa at interface level done

2.This is 4 ignoring checking mismatch in mtu during DD packet exchange.By default its cheched and if mis-match is there then the ospf neiborship stuks between exstart and exchange states.

10xs Freinds

bvsnarayana03
Level 5
Level 5

1. Check if the 2 routers are OSPF neighbors "sh ip ospf nei".

2. OSPF checks whether neighbors are using the same MTU on a common interface. This check is performed when neighbors exchange Database Descriptor (DBD) packets. If the receiving MTU in the DBD packet is higher than the IP MTU configured on the incoming interface, OSPF adjacency will not be established. "mtu-ignore" command was introduced to turn off the MTU mismatch detection.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: