01-03-2008 08:06 AM - edited 03-15-2019 08:01 AM
I'm looking for the command to be able to team the 2 ethernet ports to act as if it's one. I've done this in CCM 5 but cannot find the command.
01-03-2008 08:59 AM
Hi Tony,
Have a look at this good answer from Gonz;
http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&forum=Unified%20Communications%20and%20Video&topic=IP%20Telephony&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.1ddf24d8/0#selected_message
Hope this helps!
Rob
01-03-2008 09:56 AM
that was it, I that I found it in the forums early.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community
