call not going to pstn

Unanswered Question
Jan 4th, 2008

i have a callmanager infrastructure i am able to call local phones but i can not call pstn i m using mgcp as signaling protocol what is going wrong ?

Attached here is my gateway config

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Rajesh Revuru Fri, 01/04/2008 - 11:24


1. Can you give us more details about type of connection you have for PSTN( Ex: FXO,PRI/BRI)

2. How is route pattern is configured.

3. What happens when you dial a PSTN number ( Fast busy or Any recorded announcements) ?

kolawole1 Sat, 01/05/2008 - 04:52

I have an fxo connection to pstn

I create 3 route pattern and assign each to a partition and then add partition to css

If i dialed pstn number i hear regular tones and some beeps

i was able to call other local ip phones


This Discussion