cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
760
Views
0
Helpful
1
Replies

Resource Manager Essentials - Config Archival Status

jahangeer_abdul
Level 1
Level 1

Hi,

I could not able to succeed in Config Archival Status. I am getting the following error.

1. 10.10.X.X PRIMARY STARTUP Jan 01 2008 15:26:32 TELNET: Failed to establish TELNET connection to 10.10.X.X - Cause: Authentication failed on device 3 times.

2. 10.10.X.X PRIMARY RUNNING Jan 01 2008 15:26:34 TELNET: Failed to establish TELNET connection to 10.10.X.X - Cause: Authentication failed on device 3 times.

Kindly post your valuable recommendation inorder to solve this Issue.

Thanks,

Jahangeer

1 Reply 1

Joe Clarke
Cisco Employee
Cisco Employee

This error is almost always correct. The credentials for these devices is incorrect in DCR. Go to Common Services > Device and Credentials > Device Management, and re-enter the proper credentials in order for one to telnet and enable oneself on these devices.

Then, go to RME > Devices > Device Management > Device Credential Verification Jobs, and run a job to test the telnet and enable credentials for these devices to make sure they have been correctly entered.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco