Internet Protocol Processing Error Message

newnetman · ‎01-06-2008

Here again Friends with an error message disallowing communication two serial interfaces. The interface and the line is up as you can see from the sh ip int s1/0 command but could not ping the second device because of this error.

Serial1/0 is up, line protocol is up

Internet protocol processing disabled

Please help out somebody!!!!!!!!

Regards

Richard Burts · ‎01-06-2008

That message would typically either mean that the interface did not have an IP address configured or perhaps that the router was configured with no ip routing. My guess at this point is that the interface does not have a valid IP address configured. Can you post the output of show ip interface brief and perhaps post the configuration of the interface.

HTH

Rick

HTH

Rick

newnetman · ‎01-06-2008

Heyyyy Rick you the mannnn!!!!!!!!!!!

Thanks a billion for your help. I actually placed the IP on a wrong interface.

It's now resolved with your help.

Most grateful

Richard Burts · ‎01-06-2008

I am glad that my response pointed you in the right direction.

HTH

Rick

HTH

Rick