01-06-2008 10:58 PM - edited 03-05-2019 08:18 PM
Hi
I am very very confused with few technologies in switching...
We configured the switch port as follow:
switchport access vlan 30
switchport mode access
switchport voice vlan 70
switchport port-security maximum 3
switchport port-security
switchport port-security aging time 2
switchport port-security violation restrict
switchport port-security aging type inactivity
srr-queue bandwidth share 10 10 60 20
srr-queue bandwidth shape 10 0 0 0
mls qos trust device cisco-phone
mls qos trust cos
no snmp trap link-status
auto qos voip cisco-phone
spanning-tree portfast
-----------------------------------------
When I run the show mac address-table on port, it showed as follow:
Vlan Mac Address Type Ports
---- ----------- -------- -----
30 0017.0845.ccba STATIC Fa0/3
70 001a.a162.836c STATIC Fa0/3
Total Mac Addresses for this criterion: 2
By right, it should be shown as dynamic but most of the switch port shown as static.
Make the situation worse, we have upgraded the ios and new ios shown the mac address as dynamic(which is correct) but 3 mac address entry.
Can someone advice why it is behaving like that in different ios?
Thank you.
Best Regards
Joe
01-07-2008 07:39 AM
Hi Joe,
Can you please update your switch model and the old release version and the new version you upgraded?
Regards,
Ankur
01-07-2008 04:28 PM
Hi Ankur
Switch is 3560 and ios versions are 12.2(25)SEE and 12.2(40) SE.
It is very weired problem. Thanks for your help.
Regards
Joe
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: