01-07-2008 06:48 AM - edited 03-03-2019 08:09 PM
I am wanting to connect multiple internet connections (T3,Cable Modem,DSL) each direcly connected to the switch and do load balancing between them. Of course each interface on the switch will have IP blocks setup and I need to NAT them.
Before I buy a Cisco Layer 3 switch (3750,3550) I want to make sure it can do this and if someone can point me in the write direction on doing it.
01-07-2008 06:51 AM
Hi Friend,
3750 and 3550 does not support NAT. Your loadbalancing is still possible on these switches but Natting is not posible.
HTH
Ankur
*Pls rate all helpfull post
01-07-2008 06:56 AM
Thank You
I was thinking if it was a layer 3 switch it will do NAT but I guess not
What you you recommend for what I am trying to do?
01-07-2008 07:09 AM
Hi Friend,
I believe router with respective interface or if budget is not a concern than 6500 switch.
Regards,
Ankur
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide