dot11 carrier busy command

Unanswered Question
Jan 7th, 2008

I am getting 100% busy on all channels when running a "dot carrier busy" command on an AP, other APs close by are OK, so I take it there must be a radio fault, is thereany fix for this?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Anonymous (not verified) Fri, 01/11/2008 - 14:37

This might be a fault with Radio. Try to reset the AP and check again. You can also try upgrading the software.

Richard Bradfield Sat, 01/12/2008 - 13:11

reloading the AP made no difference,seems to bea H/W problem, so the APs have been swapped out


This Discussion



Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode