QOS only matching on Precedence 6 and 7

Unanswered Question
Jan 8th, 2008
User Badges:


I have this issue on Cisco 7206VXR whereby the configured class maps only match on IP predence 6 and 7. I have configured seven class maps to match on each of the seven IP Precedence values. The Ip precedence is being set upstream by an avaya phone from precedence 1 to 7 and I have confirmed, by sniffers, that the right precedence is being set on packets.

I have configured the interface where the policy is applied outbound with the following command:

interface POS2/0

mtu 1600

ip address X.X.X.X X.X.X.X

load-interval 30

crypto map XXXXX

max-reserved-bandwidth 100

service-policy output XXX

Router model Cisco 7206VXR (NPE-G2)


I removed and reapplied the config, but there is still only a match only on precedence 6 and seven.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
bvsnarayana03 Tue, 01/08/2008 - 06:16
User Badges:
  • Silver, 250 points or more

Precedence 6 & 7 are reserved values & not meant to be used for user traffic. If you are talking about avaya phones then, they mark voice traffic with Prec 5 & signalling traffic with Prec 3.


This Discussion