01-08-2008 11:44 AM - edited 03-03-2019 08:10 PM
Hello,
1. Is it possible to channelize (more than 2 channels) all the four (4) E1 ports on a Cisco 2821 router with an NM-2CE1T1-PRI card with a VWIC2-2MFT-G703 module plugged in it.
2. Is it possible to channelize (more than 2 channels) the VWIC2-2MFT-G703 module when it is plugged directly on the router motherboard?
Thank you.
01-08-2008 02:36 PM
1. Yes. But you don't need any VWIC module plugged, NM-2CE1T1-PRI has T1/E1 ports.
2. Yes.
Hope this helps, please rate post if it does!
01-08-2008 09:10 PM
Hi,
Why is it that I get the error message that "there are not enough resources" when trying to channelize the onboard VWIC2 E1 card?
01-09-2008 03:20 AM
The VWICs also support a channelized capability where the T1 or E1 service can be flexibly split into two or more fractional channel groups. Thus a single physical port can provide connection to multiple sites. (Note: when choosing this mode only a single port can be supported in each WIC slot.)
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: