HWIC-1FE card doesn't show up in Cisco 2811

Unanswered Question
Jan 9th, 2008
User Badges:

I have 3 1DSU-T1V2 cards in HWIC0-2 slots and tried to plug a HWIC-1FE in the HWIC3 slot but it is not showing up. I have upgraded the IOS to 12.4(12b) from 12.4(3g) but it didn't help. All the lights are green but it doesn't show up in either the cli or sdm. The router was powered down while the card was inserted. Any suggestions?

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Thu, 01/10/2008 - 05:12
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member


you need a miniumum of 12.4(11)XJ4 or 12.4(15)T! for the card to be supported, as described in data sheet.

Hope this helps, please rate post if it does!


This Discussion