MCM Gatekeeper 12.4(17) "show gatek calls" not making sense

Unanswered Question
Jan 9th, 2008
User Badges:

Sometimes when I do a "show gatek calls" to view current Video calls, the information show for a particular call shows the H323ID calling itself, however it shows different E.164 address for SRV and DST endpoint. This does not look right to me. Calls are still being connected fine, however I would like to know what would cause this particular information to appear on the call log. I have attached the debug log and "show gatek calls"




  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
commengineer Wed, 01/16/2008 - 08:05
User Badges:

The current GW2P Gateway Cards register with the Gatekeeper with Service prefixes. show gatek gw-type prefix. The GW service prefixes were setup from the get go. thats not the problem. I believe The problem has to do with LRQ(Location_Request) timing. Everytime the GK receives information from the GWs, endpoints or MCUs the information is then displayed on the show Gatek calls display. I have a TAC case in, and IOS Engineers looking at the case. I still do not have a solid answer to this.

Actions

This Discussion