CM 6.x - BLF and CCMuser

Unanswered Question
Jan 10th, 2008
User Badges:

Is it possible for a end user to configure their own BLF/SD from the ccmuser (not the ccmadmin)?

Any ideas how to move that administration to the end users?

Thanks!

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
e.huntley Thu, 01/10/2008 - 12:08
User Badges:

Yes they can, you just have to make sure that you have given them the proper button template on their phone to allow those buttons

mtkalec Fri, 01/11/2008 - 00:00
User Badges:

How?

I can only see SD lines as end user (ccmuser web pages) but not the BLF/SD lines.


Rob Huffman Sat, 01/12/2008 - 10:52
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Miljenko,


Sadly only the ccmadmin can setup BLF/SD. Here is a reference to this fact;


Cisco Unified CallManager supports the ability for a speed dial to have presence capabilities via a busy lamp field (BLF) speed dial. BLF speed dials work as both a speed dial and a presence indicator.Only the system administrator can configure a BLF speed dial; a system user is not allowed to configure a BLF speed dial.


States are:


Idle


Busy


Unknown


http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_implementation_design_guide_chapter09186a008070bc02.html#wp1070507



Hope this helps!

Rob

Actions

This Discussion