ME3400 configuration

Unanswered Question
Jan 10th, 2008
User Badges:

Hi,


we need to temporary setup the ME3400 switch to interconnect the two sites. Could somebody tell me how to configure the ME3400 based on the attached network diagram. I only have one unit of the ME3400 switch loan from cisco.



Attachment: 
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
william.caban Fri, 01/11/2008 - 03:37
User Badges:


!

system mtu 1546 ! Max for FE Interfaces

vlan dot1q tag native ! recommended for security

errdisable recovery cause l2ptguard ! if thresholds are set

!

interface

switchport access vlan

switchport mode dot1q-tunnel

l2protocol-tunnel


l2protocol-tunnel shutdown-threshold ! recomended for protection

l2protocol-tunnel drop-threshold !recommended for protection

!


Finally, if you set any of the port as Dot1q you must change the interface-type. This new in the ME series.


More details and configuration options are available at "Cisco ME 3400 Switch Software Configuration Guide"

http://www.cisco.com/univercd/cc/td/doc/product/metro/me3400/12244se/scg/index.htm


-W

Actions

This Discussion