1811 router w. bridging turned on, question about the MAC address table

Unanswered Question
Jan 10th, 2008

I have an 1811 router with bridging turned on (needed for wireless to work) and a (non-Cisco) switch plugged into one of the ports. When I do a "show mac-address-table", I only see one MAC address per port... shouldn't I see a bunch of MAC addresses on the port that has the switch? The site is reporting intermittent connection problems to devices on the switch and I'm thinking it's because it doesn't know where to send the packet. Do I need to enable something to turn on multiple MAC addresses on a port?

I have done a "bridge mac-address-table limit 0" ("0" disables the limit), but I still don't see multiple MACs per port

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)


This Discussion