01-10-2008 11:27 AM - edited 03-05-2019 08:23 PM
Guys,
This cant be right can it? I want to monitor two ports on a ws-6724-sfp on a 5400 with a sup 720?
% This platform allows a maximum of 1 TX monitor interface(s)
Can it?
Many thx
Ken
6500switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
6500switch(config)#monitor session 1 source interface Gi2/1
6500switch(config)#^Z
6500switch#sh monitor
Session 1
---------
Type : Local Session
Source Ports :
Both : Gi2/1
6500switch#conf t
Enter configuration commands, one per line. End with CNTL/Z.
6500switch(config)#monitor session 1 source interface Gi1/1
% This platform allows a maximum of 1 TX monitor interface(s)
6500switch(config)#^Z
6500switch#sh monitor
Session 1
---------
Type : Local Session
Source Ports :
RX Only : Gi1/1
Both : Gi2/1
6500switch#conf t
01-16-2008 03:29 PM
This issue is due to the hardware limitations of Cisco Catalyst switches. Traffic monitoring in a SPAN session has these restrictions:
1. You can monitor incoming traffic on a series or range of ports and VLANs.
2. You can monitor outgoing traffic on a single port.
3. You cannot monitor outgoing traffic on multiple ports.
4. You cannot monitor outgoing traffic on VLANs.
04-29-2008 06:32 AM
You need to include a "show ver" with your post, but this is the general guidelines:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide