01-10-2008 11:39 AM - edited 03-05-2019 08:24 PM
Hello Experts!
I am looking for the cable and baud rate for connecting to WS-SUP32-10GE-3B module. On the Cisco website (http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/hardware/Chassis_Installation/Cat6500/03instal.pdf) it says that sup module for 6513 uses a rollover cable at 9600 8 none 1. However,this did not work with my current sup32 module. Does anyone have a suggestion?
Thanx
01-10-2008 05:31 PM
Computers usually have a DB-9 serial port are you sure the adapter you are using has the correct pinouts. If you have any doubts the standard one piece console cable used for other cisco devices should work.
01-10-2008 05:34 PM
Thanks for your input. Issue was the standard one piece console cable was bad. I replaced it with a db9 connector and rollover cable and was able to connect.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: