cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
425
Views
0
Helpful
4
Replies

Unity 4.X - Call transfer to "0"

vmani
Level 1
Level 1

Hi,

Hi,

We have Unity 4.0(4). If someone calls in, asks for an employee, gets their voicemail, presses 0 to get back to the operator, they get a message that always says the operator is unavailable. How do I troubleshoot this issue?

Thanks

4 Replies 4

Tommer Catlin
VIP Alumni
VIP Alumni

For the subscriber you have a known problem, log into Unity SA

Pull up the subscriber

click on Caller Input

See where Caller Input 0 is going to

Typically, it is going to the "Operator" call handler. This would a transfer rule.

Open up the Operator CallHandler

Click on Transfer

Look to see what extension the Operator is at. If there is no number, then this is why.

Make sense?

ranpierce
Level 6
Level 6

when press 0 it is going to the operator call handler. it sounds like it is working normal. pressing 0 and no one answers.

Check to see what the call transfer settings are

Call Transfer settings for the "operator" call handler are:

Status: Enabled

Tranfer incoming calls: No (send directly to his handlers greeting)

Transfer type: Release to switch.

If you send calls directly to the operators greeting that is expected behavior. That is the system greeting you hear I think.

You need to give the operator an extension. Or have it transfer to a subscriber extension, or record a greeting.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: