Identify "PT in progress" traffic on WAAS 4.0.13

Unanswered Question
Jan 10th, 2008
User Badges:

Hi there, i'd like to identify the "PT in progress" traffic on my WAE.

The reason is that i've a high rate of "PT in Progress" traffic.

In Progress:

Bytes 5877 5809

Packets 114 120

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Zach Seils Fri, 01/11/2008 - 05:06
User Badges:
  • Cisco Employee,


Traffic marked as "PT In Progress" happens for the following reasons:

1. The TCP connection was already established before being redirected to the WAE.

2. A TCP connection marked as pass-through was idle for more than 10 seconds, then began passing traffic again.

In both cases, the traffic is classified as "PT In Progress".


Dev Vishwakarma Mon, 03/28/2016 - 08:05
User Badges:
  • Cisco Employee,

PT in progress is seen generally when the TCP session was established before the WAAS could see it. Meaning the WAAS is only seen data of that session and did not see the handshake.


This Discussion