01-10-2008 11:05 PM
Hi there, i'd like to identify the "PT in progress" traffic on my WAE.
The reason is that i've a high rate of "PT in Progress" traffic.
In Progress:
Bytes 5877 5809
Packets 114 120
01-11-2008 05:06 AM
Dieter,
Traffic marked as "PT In Progress" happens for the following reasons:
1. The TCP connection was already established before being redirected to the WAE.
2. A TCP connection marked as pass-through was idle for more than 10 seconds, then began passing traffic again.
In both cases, the traffic is classified as "PT In Progress".
Zach
03-28-2016 08:05 AM
PT in progress is seen generally when the TCP session was established before the WAAS could see it. Meaning the WAAS is only seen data of that session and did not see the handshake.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: