Tell Pix to use different external IP

Unanswered Question
Jan 12th, 2008

Hi, my cisco pix goes out on the internet on an external IP, how can I tell it to go out on a different IP? I ave many external IP's free in my scope, would I just assign another IP on the "outside" interface?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
JORGE RODRIGUEZ Sat, 01/12/2008 - 10:00

Andy, unfortuantely at this time PIX physical interface can only be configured with one Ip address, if you needed the interface IP be different from what currently is you would need to re-address the interface with desire IP address.

There are other scenarios where a physical interface may be splited into logical interface such in configurations entailing dual ISP backup where you may have outside physical interface and off it logical interfaces and still in this scenarion a logical interface is configured with only one IP adddress. I hope I have answered your concern.




This Discussion