Experts ,
Our ISP has provided with a sample configuration to setup a point to point Multilink T1 connection btw two office's.
controller T1 0/0
framing esf
clock source line primary
linecode b8zs
channel-group 0 timeslots 1-24 speed 64
!
controller T1 0/1
framing esf
linecode b8zs
channel-group 0 timeslots 1-24 speed 64
!
!
!
interface Multilink1
ip address 160.81.xx.xx 255.255.255.252
no ip proxy-arp
load-interval 30
no peer neighbor-route
ppp chap hostname group1
ppp multilink
ppp multilink fragment disable
ppp multilink group 1
!
!
interface FastEthernet0/0
ip address 192.160.xx.xx 255.255.255.0
speed auto
full-duplex
no mop enabled
!
interface Serial0/0:0
bandwidth 1536
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
encapsulation ppp
load-interval 30
no peer neighbor-route
ppp chap hostname group1
ppp multilink
!
interface FastEthernet0/1
no ip address
shutdown
duplex auto
speed auto
!
interface Serial0/1:0
bandwidth 1536
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
encapsulation ppp
load-interval 30
no peer neighbor-route
ppp chap hostname group1
ppp multilink
!
interface Serial0/2:0
bandwidth 1536
no ip address
no ip redirects
no ip unreachables
no ip proxy-arp
encapsulation ppp
load-interval 30
no peer neighbor-route
ppp chap hostname group1
ppp multilink
I have pasted only relevant part of config , the question that i have is , i see that controller T1 0/0 , has "clock source Primary" , however i don't see the same command for other T1 controllers , is that ok or ISP missed to put that command for second Controller T 0/1
Any help will be appreciated
